A modified iterative sandwich method for determination of near-solidus partial melt compositions. II. Application to determination of near-solidus melt compositions of carbonated peridotite

Publication Status is "Submitted" Or "In Press: 
LDEO Publication: 
Publication Type: 
Year of Publication: 
Journal Title: 
Contributions to Mineralogy and Petrology
Journal Date: 
Place Published: 
Tertiary Title: 
Section / Start page: 
ISBN Number: 
ISSN Number: 
Short Title: 
Accession Number: 
LDEO Publication Number: 
Call Number: 

We performed modified iterative sandwich experiments ( MISE) to determine the composition of carbonatitic melt generated near the solidus of natural, fertile peridotite +CO2 at 1,200-1,245 degrees C and 6.6 GPa. Six iterations were performed with natural peridotite (MixKLB-1: Mg# = 89.7) and similar to 10 wt% added carbonate to achieve the equilibrium carbonatite composition. Compositions of melts and coexisting minerals converged to a constant composition after the fourth iteration, with the silicate mineral compositions matching those expected at the solidus of carbonated peridotite at 6.6 GPa and 1,230 degrees C, as determined from a sub-solidus experiment with MixKLB- 1 peridotite. Partial melts expected from a carbonated lherzolite at a melt fraction of 0.01- 0.05% at 6.6 GPa have the composition of sodic iron- bearing dolomitic carbonatite, with molar Ca/(Ca + Mg) of 0.413 +/- 0.001, Ca# [100 x molar Ca/(Ca + Mg + Fe*)] of 37.1 +/- 0.1, and Mg# of 83.7 +/- 0.6. SiO2, TiO2 and Al2O3 concentrations are 4.1 +/- 0.1, 1.0 +/- 0.1, and 0.30 +/- 0.02 wt%, whereas the Na2O concentration is 4.0 +/- 0.2 wt%. Comparison of our results with other iterative sandwich experiments at lower pressures indicate that near- solidus carbonatite derived from mantle lherzolite become less calcic with increasing pressure. Thus carbonatitic melt percolating through the deep mantle must dissolve cpx from surrounding peridotite and precipitate opx. Significant FeO* and Na2O concentrations in near solidus carbonatitic partial melt likely account for the similar to 150 degrees C lower solidus temperature of natural carbonated peridotite compared to the solidus of synthetic peridotite in the system CMAS + CO2. The experiments demonstrate that the MISE method can determine the composition of partial melts at very low melt fraction after a small number of iterations.


220DYTimes Cited:2Cited References Count:31

DOI 10.1007/s00410-007-0214-8