Topic:
How to populate the Wells and Borehole Manager and/or the General Data Manager using Basemap.

Description:
How to populate the Wells and Borehole Manager and/or the General Data Manager
using the Borehole selection capabilities in Basemap.

Solution:
You can select Boreholes to list in the Wells and Borehole Manager and/or
the General Data Manager.  This is helpfull in setting up the managers to
do tasks such as assigning a checkshot survey to several boreholes at once or
deleting boreholes.  The steps to select from the basemap are as follows:

1. Open the ITC filter on all three applications.  This can be done
   by clicking on the "door" icon in the bottom right corner of the 
   screen making sure it is open.  If it is open already, you do not
   have to click on it.
       
2. Post the boreholes in Basemap using Post -> Borehole -> select the 
   borehole appearance and set, click on the "down" arrow and then OK.
       
3. Once the boreholes are posted, go to Send -> Boreholes.  Click on MB3
   -> Control and the control box will pop up.  Click on the diamond next 
   to "inclusion polygon" so that it is red and click close.
       
4. Draw a polygon around the wells that you wish to be sent to the
   data managers by using MB1 to digitize the points and MB2 to
   undo.  When the polygon is finished, MB3 -> Break and the selected
   boreholes will be sent to the managers.  




Last Modified on: 05-MAY-99