--- a/MASTER.cmd	Thu Nov 21 14:01:21 2013 +0000
+++ /dev/null	Thu Jan 01 00:00:00 1970 +0000
@@ -1,68 +0,0 @@
-;======================================================================
-;                    M A S T E R . C M D 
-;                    doc: Tue Jun 15 11:46:07 2004
-;                    dlm: Fri Jan  7 23:25:34 2011
-;                    (c) 2004 A.M. Thurnherr
-;                    uE-Info: 22 1 NIL 0 0 72 2 2 8 NIL ofnI
-;======================================================================
-
-; This is the default master/downlooker command file
-
-; NOTES:
-;   - this version requires firmware 16.30 or higher
-;   - should contain only commands that change factory defaults
-;   - assumes that WM15 (LADCP) mode is installed
-;   - collect data in beam coordinates
-;   - staggered single-ping ensembles every 1.3s/1.5s
-;   - narrow bandwidth
-;   - 25x 8m cells
-
-; HISTORY:
-;   Jan  7, 2011: - created for Firmware 16.30 or higher from old version
-;		  - increased pinging rate
-
-WM15			; water mode 15 (LADCP)
-
-TC2			; ensembles per burst
-LP1			; pings per ensemble
-TB 00:00:02.80		; time per burst
-TE 00:00:01.30		; time per ensemble
-TP 00:00.00		; time between pings
-
-LN25			; number of depth cells
-LS0800			; bin size [cm]
-LF0			; blank after transmit [cm]
-
-LW1			; narrow bandwidth LADCP mode
-LV400			; ambiguity velocity [cm/s]
-
-SM1			; master
-SA011			; send pulse before each ensemble
-SB0			; disable hardware-break detection on Channel B (ICN118)
-SW5500			; wait .5500 s after sending sync pulse
-SI0			; # of ensembles to wait before sending sync pulse
-
-EZ0011101		; Sensor source:
-			;	- manual speed of sound (EC)
-			;	- manual depth of transducer (ED = 0 [dm])
-			;	- measured heading (EH)
-			;	- measured pitch (EP)
-			;	- measured roll (ER)
-			;	- manual salinity (ES = 35 [psu])
-			;	- measured temperature (ET)
-
-EX00100			; coordinate transformation:
-			;	- radial beam coordinates (2 bits)
-			;	- use pitch/roll (not used for beam coords?)
-			;	- no 3-beam solutions
-			;	- no bin mapping
-
-CF11101			; Flow control:
-			;	- automatic ensemble cycling (next ens when ready)
-			;	- automatic ping cycling (ping when ready)
-			;	- binary data output
-			;	- disable serial output
-			;	- enable data recorder
-
-CK			; keep params as user defaults (across power failures)
-CS			; start pinging